Juniper ACX2000

lcc number—(TX Matrix router and TX Matrix Plus router only) (Optional) Line-card
chassis number.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
Required Privilege
Level
view
Related
Documentation
request chassis fpc•
• show chassis fpc-feb-connectivity
• show chassis fabric fpcs
• Configuring the Junos OS to Resynchronize FPC Sequence Numbers with Active FPCs
when an FPC Comes Online
• MX960 Flexible PIC Concentrator Description
• ACX2000 and ACX2100 Routers Hardware and CLI Terminology Mapping on page 33
• enhanced-mode
List of Sample Output show chassis fpc (EX6210 Switch) on page 2043
show chassis fpc (M10 Router) on page 2044
show chassis fpc (M20 Router) on page 2044
show chassis fpc detail (M Series Routers) on page 2044
show chassis fpc detail (vMX on NFX250) on page 2044
show chassis fpc detail (MX80 Router) on page 2044
show chassis fpc (MX104 Router) on page 2045
show chassis fpc detail (MX104 Router) on page 2045
show chassis fpc pic-status (MX104 Router) on page 2045
show chassis fpc (MX240 Router) on page 2046
show chassis fpc (MX480 Router) on page 2046
show chassis fpc detail (EX9200 Switch) on page 2046
show chassis fpc (MX480 Router) on page 2046
show chassis fpc (MX480 Router with 100-Gigabit Ethernet CFP) on page 2047
showchassisfpc pic-status(MX480 Router with 100-Gigabit Ethernet CFP) on page2047
show chassis fpc pic-status (EX Series Switch) on page 2047
show chassis fpc (MX480 Router with MPC4E) on page 2047
2039Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands