• MX2020 routers only—Replace slot-number with a value from 0 through 19.
• MX2008 routers only—Replace slot-number with a value from 0 through 9.
• MX10003 routers only—Replace slot-number with a value from 0 through 1.
• Other routers—Replace slot-number with a value from 0 through 7.
• EX Series switches:
• EX3200 switches and EX4200 standalone switches—Replace slot-number with
0.
• EX4200 switches in a Virtual Chassis configuration—Replace slot-number with
a value from 0 through 9 (switch’s member ID).
• EX8208 switches—Replace slot-number with a value from 0 through 7 (line
card).
• EX8216 switches—Replace slot-number with a value from 0 through 15 (line
card).
• QFX Series:
• QFX3500, QFX3600, QFX5100, and OCX Series standalone switches—Replace
slot-number with 0. In the command output, FPC refers to a line card. The FPC
number equals the slot number for the line card.
• QFabric systems—Replace slot-number with any number between 0 and 15. In
the command output, FPC refers to a line card. The FPC number equals the slot
number for the line card.
all-members—(MX Series routers and EX Series switches only) (Optional) Display PIC
information for all member routers in the Virtual Chassis configuration.
interconnect-device name—(QFabric systems only) (Optional) Display PIC information
for a specified Interconnect device.
lcc number—(TX Matrix and TX Matrix Plus routers only) (Optional) On a TX Matrix router,
display PIC information for a specified T640 router (or line-card chassis) that is
connected to the TX Matrix router. On a TX Matrix Plus router, display PIC information
for a specified router (line-card chassis) that is connected to the TX Matrix Plus
router.
Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
2335Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
