Table 137: show class-of-service interface Output Fields (continued)
Field DescriptionField Name
Number of queues you can configure on the interface.Maximum usable
queues
Maximum number of queues you can use.Maximum usable
queues
Number of queues created in addition to the default queues. Supported only on Trio MPC/MIC
interfaces on MX Series routers.
(Enhanced subscriber management for MX Series routers) This field is not displayed for enhanced
subscriber management.
Total non-default
queues created
(QFX3500 switches only) IEEE 802.1p code point (priority) rewrite value. Incoming traffic from the
Fibre Channel (FC) SAN is classified into the forwarding class specified in the native FC interface
(NP_Port) fixed classifier and uses the priority specified as the IEEE 802.1p rewrite value.
Rewrite Input IEEE
Code-point
Maximum transmission rate on the physical interface. You can configure the shaping rate on the
physical interface, or on the logical interface, but not on both. Therefore, the Shaping rate field is
displayed for either the physical interface or the logical interface.
Shaping rate
Name of the output scheduler map associated with this interface.
(Enhanced subscriber management for MX Series routers) The name of the dynamic scheduler map
object is associated with a generated UID (for example, SMAP-1_UID1002) instead of with a subscriber
interface.
Scheduler map
(QFX Series only) Name of the output fabric scheduler map associated with a QFabric system
Interconnect device interface.
Scheduler map
forwarding class sets
For Gigabit Ethernet IQ2 PICs, maximum transmission rate on the input interface.Input shaping rate
For Gigabit Ethernet IQ2 PICs, name of the input scheduler map associated with this interface.Input scheduler map
Name of the scheduler map associated with the packet forwarding component queues.Chassis scheduler map
Name and type of the rewrite rules associated with this interface.Rewrite
Name of the associated traffic control profile.
(Enhanced subscriber management for MX Series routers) The name of the dynamic traffic control
profile object is associated with a generated UID (for example, TC_PROF_100_199_SERIES_UID1006)
instead of with a subscriber interface.
Traffic-control-profile
Name and type of classifiers associated with this interface.Classifier
Name of the forwarding map associated with this interface.Forwarding-class-map
(QFX Series and EX4600 switches only) Congestion notification state, enabled or disabled.Congestion-notification
Name of a logical interface.Logical interface
2423Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands