Table 144: ATM show interfaces Output Fields
Level of OutputField DescriptionField Name
Physical Interface
All levelsName of the physical interface.Physical interface
All levelsState of the interface. Possible values are described in the “Enabled Field”
section under Common Output Fields Description.
Enabled
All levelsConfigured interface description.Description
detail extensive nonePhysical interface's index number, which reflects its initialization sequence.Interface index
detail extensive noneSNMP index number for the physical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsEncapsulation being used on the physical interface:
• ATM-CCC-CELL-RELAY—ATM cell relay for CCC.
• ATM-CCC-VC-MUX—ATM virtual circuit (VC) for CCC.
• ATM-CISCO-NLPID—Cisco-compatible ATM NLPID encapsulation.
• ATM-MIPP-LLC—ATM MLPPP over ATM Adaptation Layer 5 (AAL5)/logical
link control (LLC).
• ATM-NLPID—ATM NLPID encapsulation.
• ATM-PPP-LLC—ATM PPP over AAL5/LLC.
• ATM-PPP-VC-MUX—ATM PPP over raw AAL5.
• ATM-PVC—ATM permanent virtual circuits.
• ATM-SNAP—ATM LLC/SNAP encapsulation.
• ATM-TCC-SNAP—ATM LLC/SNAP for translational cross-connection.
• ATM-TCC-VC-MUX—ATM VC for translational cross-connection.
• ATM-VC-MUX—ATM VC multiplexing.
• ETHER-OVER-ATM-LLC—Ethernet over ATM (LLC/SNAP) encapsulation.
• ETHER-VPLS-OVER-ATM-LLC—Ethernet VPLS over ATM (bridging)
encapsulation.
Link-level type
All levelsMTU size on the physical interface.MTU
All levelsReference clock source: Internal or External.Clocking
All levelsFraming mode: SONET or SDH.framing Mode
All levelsSpeed at which the interface is running as represented by the interface type
(for example, OC3, ADSL2+, and SHDSL(2-wire).
Speed
All levelsWhether loopback is enabled and the type of loopback (local or remote).Loopback
All levelsWhether payload scrambling is enabled.Payload scrambler
Copyright © 2017, Juniper Networks, Inc.2472
ACX Series Universal Access Router Configuration Guide