Juniper ACX2000 Configuration Guide

Rx-UUS 1
Tx-UUS 0
FE-Rx-SES 0
FE-Rx-UAS 0
FE-Rx-UUS 0
FE-Tx-UUS 0
show interfaces extensive (T1, TDM-CCC-SATOP)
user@host> show interfaces t1-1/0/0:1:1 extensive
Physical interface: t1-1/0/0:1:1, Enabled, Physical link is Down
Interface index: 153, SNMP ifIndex: 579, Generation: 817
Link-level type: TDM-CCC-SATOP, MTU: 1504, Clocking: Internal, Speed: T1,
Loopback: None, FCS: 16, Framing: ESF,
Parent: coc1-1/0/0:1 Interface index 152
Device flags : Present Running Down
Interface flags: Hardware-Down Point-To-Point SNMP-Traps Internal: 0x0
Link flags : None
Hold-times : Up 0 ms, Down 0 ms
CoS queues : 8 supported, 8 maximum usable queues
Last flapped : 2012-10-28 02:12:40 PDT (22:32:13 ago)
Statistics last cleared: 2012-10-29 00:44:52 PDT (00:00:01 ago)
Egress queues: 8 supported, 4 in use
Queue counters: Queued packets Transmitted packets Dropped packets
0 best-effort 0 0 0
1 expedited-fo 0 0 0
2 assured-forw 0 0 0
3 network-cont 0 0 0
Queue number: Mapped forwarding classes
0 best-effort
1 expedited-forwarding
2 assured-forwarding
3 network-control
DS1 alarms : None
DS1 defects : None
T1 media: Seconds Count State
SEF 0 0 OK
BEE 0 0 OK
AIS 0 0 OK
LOF 0 0 OK
LOS 0 0 OK
YELLOW 0 0 OK
CRC Major 0 0 OK
CRC Minor 0 0 OK
BPV 0 0
EXZ 0 0
LCV 0 0
PCV 0 0
CS 0 0
CRC 0 0
LES 0
ES 0
SES 0
SEFS 0
BES 0
UAS 0
2527Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English