Juniper ACX2000 Configuration Guide

SAToP configuration:
Payload size: 192
Idle pattern: 0xFF
Octet aligned: Disabled
Jitter buffer: packets: 8, latency: 7 ms, auto adjust: Disabled
Excessive packet loss rate: sample period: 10000 ms, threshold: 30%
DS1 BERT configuration:
BERT time period: 10 seconds, Elapsed: 0 seconds
Induced Error rate: 0, Algorithm: 2^15 - 1, O.151, Pseudorandom (9)
SONET alarms : None
SONET defects : AIS-V, RDI-V
SONET vt:
BIP-BIP2 0 0
REI-V 0 0
LOP-V 0 0 OK
AIS-V 2 0 Defect Active
RDI-V 2 0 Defect Active
UNEQ-V 0 0 OK
PLM-V 0 0 OK
ES-V 0
SES-V 0
UAS-V 2
ES-VFE 0
SES-VFE 0
UAS-VFE 0
Received SONET overhead:
V5 : 0x07
V5(cmp) : 0x02
Transmitted SONET overhead:
V5 : 0x02
Packet Forwarding Engine configuration:
Destination slot: 1
CoS information:
Direction : Output
CoS transmit queue Bandwidth Buffer Priority
Limit
% bps % usec
0 best-effort 95 1459200 95 0 low
none
3 network-control 5 76800 5 0 low
none
Logical interface t1-1/0/0:1:1.0 (Index 69) (SNMP ifIndex 580) (Generation 525)
Flags: Device-Down Point-To-Point SNMP-Traps Encapsulation: TDM-CCC-SATOP
CE info Packets Bytes Count
CE Tx 1005 192960
CE Rx 1004 192768
CE Rx Forwarded 0
CE Strayed 0
CE Lost 0
CE Malformed 0
CE Misinserted 0
CE AIS dropped 0
CE Dropped 1005 192960
CE Overrun Events 0
CE Underrun Events 0
Protocol ccc, MTU: 1504, Generation: 814, Route table: 0
Flags: Is-Primary
Copyright © 2017, Juniper Networks, Inc.2528
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English