Juniper ACX2000 Configuration Guide

Table 150: show interfaces Gigabit Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
extensiveNumber and rate of bytes and packets transiting the switch.
NOTE: For Gigabit Ethernet intelligent queuing 2 (IQ2) interfaces, the logical
interface egress statistics might not accurately reflect the traffic on the wire
when output shaping is applied. Traffic management output shaping might
drop packets after they are tallied by the Output bytes and Output packets
interface counters. However, correct values display for both of these egress
statistics when per-unit scheduling is enabled for the Gigabit Ethernet IQ2
physical interface, or when a single logical interface is actively using a shared
scheduler.
Transit statistics
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensive noneRoute table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail extensiveInformation about protocol family flags. Possible values are described in the
“Family Flags” section under Common Output Fields Description.
Flags
detail extensive none(Unnumbered Ethernet) Interface from which an unnumbered Ethernet interface
borrows an IPv4 address.
Donor interface
detail extensive none(Unnumbered Ethernet) Secondary IPv4 address of the donor loopback interface
that acts as the preferred source address for the unnumbered Ethernet interface.
Preferred source
address
detail extensiveNames of any input filters applied to this interface. If you specify a precedence
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Input Filters
detail extensiveNames of any output filters applied to this interface. If you specify a precedence
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Output Filters
detail extensive noneNumber of MAC address validation failures for packets and bytes. This field is
displayed when MAC address validation is enabled for the logical interface.
Mac-Validate
Failures
detail extensive noneInformation about the address flags. Possible values are described in the
“Addresses Flags” section under Common Output Fields Description.
Addresses, Flags
briefProtocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
protocol-family
detail extensive noneInformation about address flag (possible values are described in the “Addresses
Flags” section under Common Output Fields Description.
Flags
detail extensive noneIP address of the remote side of the connection.Destination
detail extensive noneIP address of the logical interface.Local
detail extensive noneBroadcast address of the logical interlace.Broadcast
2613Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English