Juniper ACX2000 Configuration Guide

Table 152: show interfaces (Gigabit Ethernet) Output Fields (continued)
Level of OutputField DescriptionField Name
All levels(Gigabit Ethernet interfaces) Remote fault status:
• Online—Autonegotiation is manually configured as online.
• Offline—Autonegotiation is manually configured as offline.
Remote-fault
All levelsInformation about the physical device. Possible values are described in the
“Device Flags” section under Common Output Fields Description.
Device flags
All levelsInformation about the interface. Possible values are described in the “Interface
Flags” section under Common Output Fields Description.
Interface flags
All levelsInformation about the link. Possible values are described in the “Links Flags”
section under Common Output Fields Description.
Link flags
All levels(10-Gigabit Ethernet dense wavelength-division multiplexing [DWDM]
interfaces) Displays the configured wavelength, in nanometers (nm).
Wavelength
All levels(10-Gigabit Ethernet DWDM interfaces only) Displays the frequency associated
with the configured wavelength, in terahertz (THz).
Frequency
detail extensive noneNumber of CoS queues configured.CoS queues
extensive(Gigabit Ethernet intelligent queuing 2 [IQ2] interfaces only) Number of CoS
schedulers configured.
Schedulers
detail extensiveCurrent interface hold-time up and hold-time down, in milliseconds (ms).Hold-times
detail extensive noneConfigured MAC address.Current address
detail extensive noneHardware MAC address.Hardware address
detail extensive noneDate, time, and how long ago the interface went from down to up. The format
is Last flapped:year-month-day hour:minute:second:timezone (hour:minute:second
ago). For example, Last flapped: 2002-04-26 10:52:40 PDT (04:33:20 ago).
Last flapped
NoneInput rate in bits per second (bps) and packets per second (pps). The value in
this field also includes the Layer 2 overhead bytes for ingress traffic on Ethernet
interfaces if you enable accounting of Layer 2 overhead at the PIC level or the
logical interface level.
Input Rate
NoneOutput rate in bps and pps. The value in this field also includes the Layer 2
overhead bytes for egress traffic on Ethernet interfaces if you enable accounting
of Layer 2 overhead at the PIC level or the logical interface level.
Output Rate
detail extensiveTime when the statistics for the interface were last set to zero.Statistics last cleared
detail extensiveLayer 2 overhead in bytes that is accounted in the interface statistics for egress
traffic.
Egress account
overhead
Copyright © 2017, Juniper Networks, Inc.2626
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English