Juniper ACX2000 Configuration Guide

Table 152: show interfaces (Gigabit Ethernet) Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensive noneProtocol family. Possible values are described in the “Protocol Field” section
under Common Output Fields Description.
Protocol
detail extensive noneMaximum transmission unit size on the logical interface.MTU
All levelsNDP statistics for protocol inet6 under logical interface statistics.
• Max nh cache—Maximum interface neighbor discovery nexthop cache size.
• New hold nh limit—Maximum number of new unresolved nexthops.
• Curr nh cnt—Current number of resolved nexthops in the NDP queue.
• Curr new hold cnt—Current number of unresolved nexthops in the NDP queue.
• NH drop cnt—Number of NDP requests not serviced.
Neighbor Discovery
Protocol (NDP)Queue
Statistics
detail extensive noneName of the dynamic profile that was used to create this interface configured
with a Point-to-Point Protocol over Ethernet (PPPoE) family.
Dynamic Profile
detail extensive noneName of the service name table for the interface configured with a PPPoE family.Service Name Table
detail extensive noneMaximum number of PPPoE logical interfaces that can be activated on the
underlying interface.
Max Sessions
detail extensive noneState of PPPoE duplicate protection: On or Off. When duplicate protection is
configured for the underlying interface, a dynamic PPPoE logical interface cannot
be activated when an existing active logical interface is present for the same
PPPoE client.
Duplicate Protection
detail extensive noneState of the configuration to ignore DSL Forum VSAs: On or Off. When configured,
the router ignores any of these VSAs received from a directly connected CPE
device on the interface.
Direct Connect
detail extensive noneName of the access concentrator.AC Name
detail extensive noneMaximum number of MPLS labels configured for the MPLS protocol family on
the logical interface.
Maximum labels
detail extensiveNumber and rate of bytes and packets received and transmitted on the specified
interface set.
• Input bytes, Output bytes—Number of bytes received and transmitted on the
interface set. The value in this field also includes the Layer 2 overhead bytes
for ingress or egress traffic on Ethernet interfaces if you enable accounting
of Layer 2 overhead at the PIC level or the logical interface level.
• Input packets, Output packets—Number of packets received and transmitted
on the interface set.
Traffic statistics
extensiveNumber of IPv6 transit bytes and packets received and transmitted on the
logical interface if IPv6 statistics tracking is enabled.
IPv6 transit statistics
extensiveNumber and rate of bytes and packets destined to the router.Local statistics
Copyright © 2017, Juniper Networks, Inc.2638
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English