Juniper ACX2000 Configuration Guide

Table 154: show interfaces Fast Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
extensiveInformation about the CoS queue for the physical interface.
• CoS transmit queue—Queue number and its associated user-configured
forwarding class name.
• Bandwidth %—Percentage of bandwidth allocated to the queue.
• Bandwidth bps—Bandwidth allocated to the queue (in bps).
• Buffer %—Percentage of buffer space allocated to the queue.
• Buffer usec—Amount of buffer space allocated to the queue, in microseconds.
This value is nonzero only if the buffer size is configured in terms of time.
• Priority—Queue priority: low or high.
• Limit—Displayed if rate limiting is configured for the queue. Possible values
are none and exact. If exact is configured, the queue transmits only up to the
configured bandwidth, even if excess bandwidth is available. If none is
configured, the queue transmits beyond the configured bandwidth if
bandwidth is available.
CoS information
Logical Interface
All levelsName of the logical interface.Logical interface
detail extensive noneIndex number of the logical interface, which reflects its initialization sequence.Index
detail extensive noneSNMP interface index number for the logical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsInformation about the logical interface. Possible values are described in the
“Logical Interface Flags” section under Common Output Fields Description.
Flags
brief detail extensive
none
Rewrite profile applied to incoming or outgoing frames on the outer (Out) VLAN
tag or for both the outer and inner (In) VLAN tags.
• push—An outer VLAN tag is pushed in front of the existing VLAN tag.
• pop—The outer VLAN tag of the incoming frame is removed.
• swap—The outer VLAN tag of the incoming frame is overwritten with the user
specified VLAN tag information.
• push—An outer VLAN tag is pushed in front of the existing VLAN tag.
• push-push—Two VLAN tags are pushed in from the incoming frame.
• swap-push—The outer VLAN tag of the incoming frame is replaced by a
user-specified VLAN tag value. A user-specified outer VLAN tag is pushed in
front. The outer tag becomes an inner tag in the final frame.
• swap-swap—Both the inner and the outer VLAN tags of the incoming frame
are replaced by the user specified VLAN tag value.
• pop-swap—The outer VLAN tag of the incoming frame is removed, and the
inner VLAN tag of the incoming frame is replaced by the user-specified VLAN
tag value. The inner tag becomes the outer tag in the final frame.
• pop-pop—Both the outer and inner VLAN tags of the incoming frame are
removed.
VLAN-Tag
Copyright © 2017, Juniper Networks, Inc.2660
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English