Juniper ACX2000 Configuration Guide

Table 154: show interfaces Fast Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensive noneIP demultiplexing (demux) value that appears if this interface is used as the
demux underlying interface. The output is one of the following:
• Source Family Inet
• Destination Family Inet
Demux:
All levelsEncapsulation on the logical interface.Encapsulation
detail extensive noneProtocol family. Possible values are described in the “Protocol Field” section
under Common Output Fields Description.
Protocol
detail extensive noneMaximum transmission unit size on the logical interface.MTU
detail extensive noneMaximum number of MPLS labels configured for the MPLS protocol family on
the logical interface.
Maximum labels
detail extensiveNumber and rate of bytes and packets received and transmitted on the specified
interface set.
• Input bytes, Output bytes—Number of bytes received and transmitted on the
interface set
• Input packets, Output packets—Number of packets received and transmitted
on the interface set.
Traffic statistics
extensiveNumber of IPv6 transit bytes and packets received and transmitted on the
logical interface if IPv6 statistics tracking is enabled.
IPv6 transit
statistics
extensiveNumber and rate of bytes and packets destined to the routing device.Local statistics
extensiveNumber and rate of bytes and packets transiting the switch.
NOTE: For Gigabit Ethernet intelligent queuing 2 (IQ2) interfaces, the logical
interface egress statistics might not accurately reflect the traffic on the wire
when output shaping is applied. Traffic management output shaping might
drop packets after they are tallied by the Output bytes and Output packets
interface counters. However, correct values display for both of these egress
statistics when per-unit scheduling is enabled for the Gigabit Ethernet IQ2
physical interface, or when a single logical interface is actively using a shared
scheduler.
Transit statistics
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensive noneRoute table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail extensiveInformation about protocol family flags. Possible values are described in the
“Family Flags” section under Common Output Fields Description.
Flags
detail extensive none(Unnumbered Ethernet) Interface from which an unnumbered Ethernet interface
borrows an IPv4 address.
Donor interface
2661Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English