Juniper ACX2000 Configuration Guide

Table 154: show interfaces Fast Ethernet Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensive none(Unnumbered Ethernet) Secondary IPv4 address of the donor loopback interface
that acts as the preferred source address for the unnumbered Ethernet interface.
Preferred source
address
detail extensiveNames of any input filters applied to this interface. If you specify a precedence
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Input Filters
detail extensiveNames of any output filters applied to this interface. If you specify a precedence
value for any filter in a dynamic profile, filter precedence values appear in
parenthesis next to all interfaces.
Output Filters
detail extensive noneNumber of MAC address validation failures for packets and bytes. This field is
displayed when MAC address validation is enabled for the logical interface.
Mac-Validate
Failures
detail extensive noneInformation about the address flags. Possible values are described in the
“Addresses Flags” section under Common Output Fields Description.
Addresses, Flags
briefProtocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
protocol-family
detail extensive noneInformation about address flag (possible values are described in the “Addresses
Flags” section under Common Output Fields Description.
Flags
detail extensive noneIP address of the remote side of the connection.Destination
detail extensive noneIP address of the logical interface.Local
detail extensive noneBroadcast address of the logical interlace.Broadcast
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
Sample Output
show interfaces (Fast Ethernet)
user@host> show interfaces fe-0/0/0
Physical interface: fe-0/0/0, Enabled, Physical link is Up
Interface index: 128, SNMP ifIndex: 22
Link-level type: Ethernet, MTU: 1514, Speed: 100mbps, Loopback: Disabled,
Source filtering: Disabled, Flow control: Enabled
Device flags : Present Running
Interface flags: SNMP-Traps Internal: 0x4000
CoS queues : 4 supported, 4 maximum usable queues
Current address: 00:00:5e:00:53:38, Hardware address: 00:00:5e:00:53:38
Last flapped : 2006-01-20 14:50:58 PST (2w4d 00:44 ago)
Input rate : 0 bps (0 pps)
Output rate : 0 bps (0 pps)
Active alarms : None
Active defects : None
Logical interface fe-0/0/0.0 (Index 66) (SNMP ifIndex 198)
Flags: SNMP-Traps Encapsulation: ENET2
Copyright © 2017, Juniper Networks, Inc.2662
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English