Table 178: show oam ethernet connectivity-fault-management interfaces Output
Fields (continued)
Level of OutputField DescriptionField Name
detail extensiveIndicates whether the AIS is triggered or is cleared.Alarm Indication
Signal
detail extensiveNumber of CCMs transmitted.CCMs sent
detail extensiveNumber of CCMs received out of sequence.CCMs received out
of sequence
detail extensiveNumber of loopback request messages (LBMs) sent.LBMs sent
detail extensiveNumber of loopback response messages (LBRs) received that were valid
messages and in sequence.
Valid in-order LBRs
received
detail extensiveNumber of LBRs received that were valid messages and not in sequence.Valid out-of-order
LBRs received
detail extensiveNumber of LBRs received that were corrupted.LBRs received with
corrupted data
detail extensiveNumber of LBRs transmitted.LBRs sent
detail extensiveLinktrace messages (LTMs) transmitted.LTMs sent
detail extensiveLinktrace messages received.LTMs received
detail extensiveLinktrace responses (LTRs) transmitted.LTRs sent
detail extensiveLinktrace responses received.LTRs received
detail extensiveSequence number of next LTM request to be transmitted.Sequence number
of next LTM request
detail extensiveIf the interface is attached to an initiator MEP for a one-way ETH-DM session:
Number of one-way delay measurement (1DM) PDU frames sent to the peer
MEP in this session.
For all other cases, this field displays 0.
1DMs sent
detail extensiveIf the interface is attached to a receiver MEP for a one-way ETH-DM session:
Number of valid 1DM frames received.
For all other cases, this field displays 0.
Valid 1DMs received
detail extensiveIf the interface is attached to a receiver MEP for a one-way ETH-DM session:
Number of invalid 1DM frames received.
For all other cases, this field displays 0.
Invalid 1DMs
received
2771Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
