Juniper ACX2000 Configuration Guide

Table 178: show oam ethernet connectivity-fault-management interfaces Output
Fields (continued)
Level of OutputField DescriptionField Name
detail extensiveIf the interface is attached to a receiver MEP for a one-way ETH-DM session:
Number of out-of-sync one-way delay measurement request packets received.
Out of sync 1DMs
received
detail extensiveIf the interface is attached to an initiator MEP for a two-way ETH-DM session:
Number of Delay Measurement Message (DMM) PDU frames sent to the peer
MEP in this session.
For all other cases, this field displays 0.
DMMs sent
detail extensiveIf the interface is attached to an initiator MEP for a two-way ETH-DM session:
Number of valid two-way delay measurement request packets received.
Valid DMMs
received
detail extensiveIf the interface is attached to an initiator MEP for a two-way ETH-DM session:
Number of invalid two-way delay measurement request packets received.
Invalid DMMs
received
detail extensiveIf the interface is attached to a responder MEP for a two-way ETH-DM session:
Number of delay measurement reply (DMR) frames sent.
For all other cases, this field displays 0.
DMRs sent
detail extensiveIf the interface is attached to an initiator MEP for a two-way ETH-DM session:
Number of valid DMRs received.
For all other cases, this field displays 0.
Valid DMRs
received
detail extensiveIf the interface is attached to an initiator MEP for a two-way ETH-DM session:
Number of invalid DMRs received.
For all other cases, this field displays 0.
Invalid DMRs
received
detail extensiveIf the interface is attached to an initiator MEP for a ETH-LM session: Number
of loss measurement message (LMM) PDU frames sent to the peer MEP in this
session.
LMM sent
detail extensiveIf the interface is attached to an initiator MEP for a ETH-LM session: Number
of valid loss measurement request packets received.
Valid LMM received
detail extensiveIf the interface is attached to an initiator MEP for a ETH-LM session: Number
of invalid loss measurement request packets received.
Invalid LMM
received
detail extensiveIf the interface is attached to a responder MEP for a ETH-LM session: Number
of loss measurement reply (LMR) frames sent.
LMR sent
detail extensiveIf the interface is attached to an initiator MEP for a ETH-LM session: Number
of valid LMR frames received.
Valid LMR received
detail extensiveIf the interface is attached to an initiator MEP for a ETH-LM session: Number
of invalid LMR frames received.
Invalid LMR
received
Copyright © 2017, Juniper Networks, Inc.2772
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English