Table 178: show oam ethernet connectivity-fault-management interfaces Output
Fields (continued)
Level of OutputField DescriptionField Name
detail extensiveNumber of valid AIS frames transmitted to the peer MEPs.Valid AIS frames
transmitted
detail extensiveNumber of valid AIS frames received from the peer MEPs.Valid AIS frames
received
detail extensiveIf the interface is attached to an initiator MEP for a ETH-SLM session: Number
of synthetic loss measurement (SLM) request packets transmitted from the
source MEP to the remote or destination MEP in this session.
SLM sent
detail extensiveIf the interface is attached to a responder MEP for a ETH-SLM session: Number
of valid SLM PDUs transmitted from the source MEP to the remote or destination
MEP.
Valid SLM received
detail extensiveIf the interface is attached to a responder MEP for a ETH-SLM session: Number
of invalid SLM PDUs transmitted from the source MEP to the remote or
destination MEP.
Invalid SLM
received
detail extensiveIf the interface is attached to a responder MEP for a ETH-SLM session: Number
detail extensive of synthetic loss reply (SLR) frames sent.
SLR sent
detail extensiveIf the interface is attached to an initiator MEP for a ETH-SLM session: Number
of valid SLR PDUs that the source MEP received from the remote or destination
MEP.
Valid SLR received
detail extensiveIf the interface is attached to an initiator MEP for a ETH-SLM session: Number
of invalid SLR PDUs that the source MEP received from the remote or destination
MEP.
Invalid SLR received
extensiveNumber of remote MEPs.Remote MEP count
extensiveMEP identifier of the remote MEP.Identifier (remote
MEP)
extensiveMAC address of the remote MEP.MAC address
(remote MEP)
extensiveState of the remote MEP.State (remote
MEP)
extensiveInterface of the remote MEP.Interface (remote
MEP)
Sample Output
show oam ethernet connectivity-fault-
2773Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands