show oam ethernet connectivity-fault-management mep-database local-mep
remote-mep on page 2798
show oam ethernet connectivity-fault-management mep-database remote-mep
(Action Profile Event) on page 2798
show oam ethernet connectivity-fault-management mep-database (Connection
Protection TLV Configured) on page 2798
show oam ethernet connectivity-fault-management mep-database on page 2799
show oam ethernet connectivity-fault-management mep-database (enhanced
continuity measurement) on page 2800
Output Fields Table 180 on page 2792 lists the output fields for the show oam ethernet
connectivity-fault-management mep-database command. Output fields are listed in the
approximate order in which they appear.
Table 180: show oam ethernet connectivity-fault-management mep-database Output Fields
Field DescriptionField Name
Maintenance domain name.Maintenance domain
name
Maintenance domain name format configured.Format (Maintenance
domain)
Maintenance domain level configured.Level
Maintenance association name.Maintenance
association name
Maintenance association name format configured.Format (Maintenance
association)
Continuity-check status.Continuity-checkstatus
Continuity-check message interval.Interval
Lost continuity-check message threshold.Loss-threshold
Status of the connection protection TLV, if configured on the MEP interface: no, yes
If yes, then the transmitted connection protection TLV is decoded and the following three fields are
displayed: Prefer me, Protection in use, FRR Flag
Connection Protection
TLV
If set to yes, the path through which CCM was transmitted is preferred (unless the path fails). It is
used for signaling a manual-switch command to remote side.
Its value can be yes or no.
Prefer me
Used for protection decision coordination. Its value is set to yes if the endpoint transmitting the CCM
is currently transmitting the user traffic to protection path.
Its value can be yes or no.
Protection in use
Copyright © 2017, Juniper Networks, Inc.2792
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
