Juniper ACX2000 Configuration Guide

Table 180: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field DescriptionField Name
Interface of the remote MEP. A seven-digit number is appended if CFM is configured to run on a routing
instance of type VPLS.
Interface
Date, time, and how long ago the remote MEP interface went from down to up. The format is Last
flapped: year-month-day hours:minutes:seconds timezone (hours:minutes:seconds ago). For example,
Last flapped: 2002-04-26 10:52:40 PDT (04:33:20 ago).
Last flapped
Whether the remote defect indication (RDI) bit is set in messages that have been received or
transmitted.
Remote defect
indication
• In the Maintenance domain section, displays the last transmitted port status TLV value.
• In the Remote MEP section, displays the last value of port status TLV received from the remote
MEP.
In the Action profile section, displays, the last occurred event port-status-tlv blocked event. This
event occurred due to the reception of blocked value in the port status TLV from remote MEP.
Port status TLV
• In the Maintenance domain section, displays the last transmitted interface status TLV value.
• In the Remote MEP section, displays the last value of interface status TLV received from the remote
MEP.
In the Action profile section, if displays, the last occurred event interface-status-tlv event ( either
lower-layer-down or down). This event occurred due to the reception of either lower or down value
in the interface status TLV from remote MEP.
Interface status TLV
Name of the action profile occurrence associated with a remote MEP.Action profile
When an action profile occurs, displays the last event that triggered it.Last event
When all the configured and occurred events (under action profile) are cleared, then the action taken
gets reverted (such as down interface is made up) and the corresponding time is noted and displayed.
Last event cleared
Action taken and the corresponding time of the action occurrence.Action
Sample Output
show oam ethernet connectivity-fault-
management mep-database
user@host> show oam ethernet connectivity-fault-management mep-database
maintenance-domain vpls-vlan2000 maintenance-association vpls-vlan200
Maintenance domain name: vpls-vlan2000, Format: string, Level: 5
Maintenance association name: vpls-vlan200, Format: string
Continuity-check status: enabled, Interval: 100ms, Loss-threshold: 3 frames
MEP identifier: 200, Direction: up, MAC address: 00:19:e2:b0:74:01
Auto-discovery: enabled, Priority: 0
Interface status TLV: none, Port status TLV: none
Connection Protection TLV: no Interface name: ge-0/0/1.0, Interface status:
Active, Link status: Up
Defects:
Remote MEP not receiving CCM : no
Copyright © 2017, Juniper Networks, Inc.2796
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English