Juniper ACX2000 Configuration Guide

Table 180: show oam ethernet connectivity-fault-management mep-database Output
Fields (continued)
Field DescriptionField Name
Sequence number of the next linktrace message request to be transmitted.Sequence number of
next LTM request
If the interface is attached to an initiator MEP for a ETH-LM session: Number of loss measurement
message (LMM) PDU frames sent to the peer MEP in this session.
LMM sent
If the interface is attached to an initiator MEP for a ETH-LM session: Number of valid loss measurement
request packets received.
Valid LMM received
If the interface is attached to an initiator MEP for a ETH LM session: Number of invalid loss
measurement request packets received.
Invalid LMM received
If the interface is attached to a responder MEP for a ETH-LM session: Number of loss measurement
reply (LMR) frames sent.
LMR sent
If the interface is attached to an initiator MEP for a ETH LM session: Number of valid LMR frames
received.
Valid LMR received
If the interface is attached to an initiator MEP for a ETH-LM session: Number of invalid LMR frames
received.
Invalid LMR received
If the interface is attached to an initiator MEP for a ETH-SLM session: Number of synthetic loss
measurement (SLM) request packets transmitted from the source MEP to the remote or destination
MEP in this session.
SLM sent
If the interface is attached to a responder MEP for a ETH-SLM session: Number of valid SLM PDUs
transmitted from the source MEP to the remote or destination MEP.
Valid SLM received
If the interface is attached to a responder MEP for a ETH-SLM session: Number of invalid SLM PDUs
transmitted from the source MEP to the remote or destination MEP.
Invalid SLM received
If the interface is attached to a responder MEP for a ETH-SLM session: Number detail extensive of
synthetic loss reply (SLR) frames sent.
SLR sent
If the interface is attached to an initiator MEP for a ETH-SLM session: Number of valid SLR PDUs that
the source MEP received from the remote or destination MEP.
Valid SLR received
If the interface is attached to an initiator MEP for a ETH-SLM session: Number of invalid SLR PDUs
that the source MEP received from the remote or destination MEP.
Invalid SLR received
MEP identifier of the remote MEP.Remote MEP identifier
State of the remote MEP: idle, start, ok, or failed.State (remote MEP)
MAC address of the remote MEP.MAC address
Whether the remote MEP MAC address was learned using automatic discovery or configured.Type
2795Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English