To Next Page

To Previous Page

Table 184: show ospf database Output Fields (continued)

Level of OutputField DescriptionField Name

All levelsType of link advertisement: ASBRSum, Extern, Network, NSSA, OpaqArea, Router,

or Summary.

Type

All levelsLSA identifier included in the advertisement. An asterisk preceding the identifier

marks database entries that originated from the local routing device.

All levelsAddress of the routing device that sent the advertisement.Adv Rtr

All levelsLink sequence number of the advertisement.Seq

All levelsTime elapsed since the LSA was originated, in seconds.Age

All levelsOptional OSPF capabilities associated with the LSA.Opt

All levelsChecksum value of the LSA.Cksum

All levelsLength of the advertisement, in bytes.Len

detail extensiveRouter link-state advertisement information:

• bits—Flags describing the routing device that generated the LSP.

• link count—Number of links in the advertisement.

• id—ID of a routing device or subnet on the link.

• data—For stub networks, the subnet mask. Otherwise, the IP address of the

routing device that generated the LSP.

• type—Type of link. It can be PointToPoint, Transit, Stub, or Virtual.

• TOS count—Number of type-of-service (ToS) entries in the advertisement.

• TOS 0 metric—Metric for ToS 0.

• TOS—Type-of-service (ToS) value.

• metric—Metric for the ToS.

Router

detail extensiveNetwork link-state advertisement information:

• mask—Network mask.

• attached router—ID of the attached neighbor.

Network

detail extensiveSummary link-state advertisement information:

• mask—Network mask.

• TOS—Type-of-service (ToS) value.

• metric—Metric for the ToS.

Summary

extensiveHow long until the LSA is regenerated.Gen timer

extensiveHow long until the LSA expires.Aging timer

extensiveHow long ago the route was installed.Installed hh:mm:ss

ago

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000