To Next Page

To Previous Page

Table 185: show ospf3 database Output Fields (continued)

Level of OutputField DescriptionField Name

detail extensiveRouter ID of the neighbor routing device (for type 2 interfaces, the attached

link’s designated router).

Nbr-rtr-id

detail extensiveCost of the router link.Metric

extensiveHow long until the LSA is regenerated, in the format hours:minutes:seconds.Gen timer

extensiveHow long until the LSA expires, in the format hours:minutes:seconds.Aging timer

extensiveHow long ago the route was installed, in the format hours:minutes:seconds.Installed nn:nn:nn

ago

extensiveHow long until the route expires, in the format hours:minutes:seconds.expires in nn:nn:nn

extensiveTime elapsed since the LSA was last transmitted or flooded to an adjacency

or an interface, respectively, in the format hours:minutes:seconds.

sent nn:nn:nn ago

extensiveIndicates that this is a local advertisement.Ours

Network (Network Link-State Advertisements)

detail extensiveOption bits carried in the network LSA.Options

detail extensiveRouter IDs of each of the routing devices attached to the link. Only routing

devices that are fully adjacent to the designated router are listed. The designated

router includes itself in this list.

Attached Router

InterArPfx (Interarea-Prefix Link-State Advertisements)

detail extensiveIPv6 address prefix.Prefix

detail extensiveOption bit associated with the prefix.Prefix-options

detail extensiveCost of this route. Expressed in the same units as the interface costs in the router

LSAs. When the interarea-prefix LSA is describing a route to a range of addresses,

the cost is set to the maximum cost to any reachable component of the address

range.

Metric