Table 185: show ospf3 database Output Fields
Level of OutputField DescriptionField Name
brief detail extensiveEntries in the link-state database for this area.OSPF link state
database, area
area-number
brief detail extensiveEntries in the AS scope link-state database.OSPF AS SCOPE
link state database
brief detail extensiveEntries in the link-local link-state database for this interface.OSPF Link-Local
link state database,
interface
interface-name
All levelsArea number. Area 0.0.0.0 is the backbone area.area
brief detail extensiveType of link advertisement: Extern, InterArPfx, InterArRtr, IntraArPrx , Link, Network,
NSSA, or Router.
Type
brief detail extensiveLink identifier included in the advertisement. An asterisk (*) preceding the
identifier marks database entries that originated from the local routing device.
ID
brief detail extensiveAddress of the routing device that sent the advertisement.Adv Rtr
brief detail extensiveLink sequence number of the advertisement.Seq
brief detail extensiveTime elapsed since the LSA was originated, in seconds.Age
brief detail extensiveChecksum value of the LSA.Cksum
brief detail extensiveLength of the advertisement, in bytes.Len
Router (Router Link-State Advertisements)
detail extensiveFlags describing the routing device that generated the LSP.bits
detail extensiveOption bits carried in the router LSA.Options
For Each Router Link
detail extensiveType of interface. The value of all other output fields describing a routing device
interface depends on the interface’s type:
• PointToPoint (1)—Point-to-point connection to another routing device.
• Transit (2)—Connection to a transit network.
• Virtual (4)—Virtual link.
Type
detail extensiveLocal interface ID assigned to the interface that uniquely identifies the interface
with the routing device.
Loc-if-id
detail extensiveInterface ID of the neighbor's interface for this routing device link.Nbr-if-id
2825Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
