Table 186: show (ospf | ospf3) interface Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensive(OSPFv2 and MD5) Time at which the routing device starts using an MD5 key
to authenticate OSPF packets transmitted on the interface on which this key
is configured. To authenticate received OSPF protocol packets, the key becomes
effective immediately after the configuration is committed. If the start time
option is not configured, the key is effective immediately for send and receive
and is displayed as Start time 1970 Jan 01 00:00:00 PST.
Start time
detail extensiveConfigured value for the Retransmit timer.ReXmit
detail extensiveType of area.Stub, Not Stub, or
Stub NSSA
Sample Output
show ospf interface brief
user@host> show ospf interface brief
Intf State Area DR ID BDR ID Nbrs
at-5/1/0.0 PtToPt 0.0.0.0 0.0.0.0 0.0.0.0 1
ge-2/3/0.0 DR 0.0.0.0 192.168.4.16 192.168.4.15 1
lo0.0 DR 0.0.0.0 192.168.4.16 0.0.0.0 0
so-0/0/0.0 Down 0.0.0.0 0.0.0.0 0.0.0.0 0
so-6/0/1.0 PtToPt 0.0.0.0 0.0.0.0 0.0.0.0 1
so-6/0/2.0 Down 0.0.0.0 0.0.0.0 0.0.0.0 0
so-6/0/3.0 PtToPt 0.0.0.0 0.0.0.0 0.0.0.0 1
show ospf interface detail
user@host> show ospf interface detail
Interface State Area DR ID BDR ID Nbrs
fe-0/0/1.0 BDR 0.0.0.0 192.168.37.12 10.255.245.215 1
Type LAN, address 192.168.37.11, Mask 255.255.255.248, MTU 4460, Cost 40
DR addr 192.168.37.12, BDR addr 192.168.37.11, Adj count 1, Priority 128
Hello 10, Dead 40, ReXmit 5, Not Stub
t1-0/2/1.0 PtToPt 0.0.0.0 0.0.0.0 0.0.0.0 0
Type P2P, Address 0.0.0.0, Mask 0.0.0.0, MTU 1500, Cost 2604
Adj count 0
Hello 10, Dead 40, ReXmit 5, Not Stub
Auth type: MD5, Active key ID 3, Start time 2002 Nov 19 10:00:00 PST
IPsec SA Name: sa
show ospf3 interface detail
user@host> show ospf3 interface so-0/0/3.0 detail
Interface State Area DR-ID BDR-ID Nbrs
so-0/0/3.0 PtToPt 0.0.0.0 0.0.0.0 0.0.0.0 1
Address fe80::2a0:a5ff:fe28:1dfc, Prefix-length 64
OSPF3-Intf-index 1, Type P2P, MTU 4470, Cost 12, Adj-count 1
Hello 10, Dead 40, ReXmit 5, Not Stub
show ospf interface detail
2837Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands