Table 186: show (ospf | ospf3) interface Output Fields (continued)
Level of OutputField DescriptionField Name
detail extensiveIndicates that this interface is configured as a secondary interface for this area.
This interface can belong to more than one area, but can be designated as a
primary interface for only one area.
Secondary
extensiveIndicates that this interface is configured with flooding reduction. All
self-originated LSAs from this interface are initially sent with the DoNotAge bit
set. As a result, LSAs are refreshed only when a change occurs.
Flood Reduction
detail extensiveRouter priority used in designated router (DR) election on this interface.Priority
extensiveList of link-state advertisements (LSAs) that might be about to flood this
interface.
Flood list
extensiveAcknowledgment list. List of pending acknowledgments on this interface.Ack list
extensiveList of packet descriptors.Descriptor list
detail extensiveConfigured value for the hello timer.Hello
detail extensiveConfigured value for the dead timer.Dead
detail extensive(OSPFv2) Authentication mechanism for sending and receiving OSPF protocol
packets:
• MD5—The MD5 mechanism is configured in accordance with RFC 2328.
• None—No authentication method is configured.
• Password—A simple password (RFC 2328) is configured.
Auth type
(Multiarea adjacency) Name of topology: default or name.Topology
extensive(OSPFv2 and LDP synchronization) Current state of LDP synchronization: in
sync, in holddown, and not supported.
LDP sync state
extensive(OSPFv2 and LDP synchronization) Reason for the current state of LDP
synchronization. The LDP session might be up or down, or adjacency might be
up or down.
reason
extensive(OSPFv2 and LDP synchronization) Configured value of the hold timer.
If the state is not synchronized, and the hold time is not infinity, the remaining
field displays the number of seconds that remain until the configured hold timer
expires.
config holdtime
detail extensive(OSPFv2) Name of the IPSec security association name.IPSec SA name
detail extensive(OSPFv2 and MD5) Number from 0 to 255 that uniquely identifies an MD5 key.Active key ID
Copyright © 2017, Juniper Networks, Inc.2836
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
