Required Privilege
Level
view
List of Sample Output show ospf interface brief on page 2837
show ospf interface detail on page 2837
show ospf3 interface detail on page 2837
show ospf interface detail(When Multiarea Adjacency Is Configured) on page 2837
show ospf interface area area-id on page 2839
show ospf interface extensive (When Flooding Reduction Is Enabled) on page 2839
show ospf interface extensive (When LDP Synchronization Is Configured) on page 2839
Output Fields Table 186 on page 2835 lists the output fields for the show(ospf| ospf3) interface command.
Output fields are listed in the approximate order in which they appear.
Table 186: show (ospf | ospf3) interface Output Fields
Level of OutputField DescriptionField Name
All levelsName of the interface running OSPF version 2 or OSPF version 3.Interface
All levelsState of the interface: BDR, Down, DR, DRother, Loop, PtToPt, or Waiting.State
All levelsNumber of the area that the interface is in.Area
All levelsAddress of the area's designated router.DR ID
All levelsBackup designated router for a particular subnet.BDR ID
All levelsNumber of neighbors on this interface.Nbrs
detail extensiveType of interface: LAN, NBMA, P2MP, P2P, or Virtual.Type
detail extensiveIP address of the neighbor.Address
detail extensiveNetmask of the neighbor.Mask
detail extensive(OSPFv3) IPv6 prefix length, in bits.Prefix-length
detail extensive(OSPFv3) OSPF version 3 interface index.OSPF3-Intf-Index
detail extensiveInterface maximum transmission unit (MTU).MTU
detail extensiveInterface cost (metric).Cost
detail extensiveAddress of the designated router.DR addr
detail extensiveAddress of the backup designated router.BDR addr
detail extensiveNumber of adjacent neighbors.Adj count
2835Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
