Table 201: show ppp statistics Output Fields (continued)
Level of OutputField DescriptionField Name
none detailNumber of PPP sessions disabled. Number of sessions where the link is either
administratively or physically down. Once the PPP process learns from the
kernel that Layer 2 is ready to send and receive traffic, it will do a phase transition
from disabled to established. When LCP and NCP transitions through states,
links transition to the establish phase when terminate packets are exchanged
or some other failure, such as authentication or expiration of a timer occurs.
Sessions in
disabled phase
none detailNumber of PPP sessions in establish phase. In order to establish communications
over a point-to-point link, each end of the PPP link must first send LCP packets
to configure and test the data link.
Sessions in
establish phase
none detailNumber of PPP sessions in authenticate phase. Each end of the PPP link must
first send LCP packets to configure the data link during the link establishment
phase. After the link has been established, PPP provides for an optional
authentication phase before proceeding to the Network-Layer Protocol (NLP)
phase.
Sessions in
authenticate phase
none detailNumber of PPP sessions in the network phase. After a link has been established
and optional facilities have been negotiated as needed by the LCP, PPP must
send Network Control Protocol (NCP) packets to choose and configure one or
more network-layer protocols, such as IP, IPX, or AppleTalk. Once each of the
chosen network-layer protocols has been configured, datagrams from each
network-layer protocol can be sent over the link.
Sessions in network
phase
none detailNumber of unique bundles to which PPP links are referring.Bundles in pending
phase
Copyright © 2017, Juniper Networks, Inc.2910
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
