Juniper ACX2000 Configuration Guide

Table 203: MX Series Routers show protection-group ethernet-ring
interface Output Fields (continued)
Field DescriptionField Name
(MX Series router only) Logical unit configured on the physical
interface.
Control Channel
Direction of the traffic.Direction
State of the ring forwarding on the interface: discarding or
forwarding.
Forward State
Whether this interface is the end of the ring: Yes or No.Ring Protection Link End
Whether there a signal failure exists on the link: Clear or Set.Signal Failure
State of the interface: For EX switches, ready, ifl ready, or
waiting. For MX routers, IFF ready or IFF disabled.
Admin State
Sample Output
show protection-group ethernet-ring interface (EX Series Switch Owner Node)
user@host> show protection-group ethernet-ring interface
Ethernet ring port parameters for protection group pg101
Interface Forward State RPL End Signal Failure Admin State
ge-0/0/3.0 discarding Yes Clear ready
ge-0/0/9.0 forwarding No Clear ready
show protection-group ethernet-ring interface (Owner Node MX Series Router )
user@host> show protection-group ethernet-ring interface
Ethernet ring port parameters for protection group pg101
Interface Control Channel Direction Forward State RPL End SF Admin State
ge-1/2/0 ge-1/2/0.100 east forwarding No Clear IFF ready
ge-1/2/2 ge-1/2/2.100 west forwarding No Clear IFF ready
show protection-group ethernet-ring interface detail (Owner Node MX Series Router )
user@host> show protection-group ethernet-ring interface detail
Ethernet ring port parameters for protection group pg101
Interface name : ge-1/2/0
Control channel name : ge-1/2/0.100
Interface direction : east
Ring Protection Link End : No
Signal Failure : Clear
Forward State : forwarding
Interface Admin State : IFF ready
Interface name : ge-1/2/2
2921Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English