Table 217: Next-hop Types Output Field Values (continued)
DescriptionNext-Hop Type
Unicast.Unicast (ucst)
List of unicast next hops. A packet sent to this next hop
goes to any next hop in the list.
Unilist (ulst)
Table 218 on page 3008 describes all possible values for the State output field. A route can
be in more than one state (for example, <Active NoReadvrt Int Ext>).
Table 218: State Output Field Values
DescriptionValue
Route needs accounting.Accounting
Route is active.Active
Path with a lower multiple exit discriminator (MED) is
available.
Always Compare MED
Shorter AS path is available.AS path
Cisco nondeterministic MED is enabled, and a path with a
lower MED is available.
Cisco Non-deterministic MED
selection
Route is a clone.Clone
Length of cluster list sent by the route reflector.Cluster list length
Route has been deleted.Delete
Exterior route.Ex
BGP route received from an external BGP neighbor.Ext
Forces all protocols to be notified of a change to any route,
active or inactive, for a prefix. When not set, protocols are
informed of a prefix only when the active route changes.
FlashAll
Route not used because of routing policy.Hidden
Route needs forwarding RPF check.IfCheck
Path through next hop with lower IGP metric is available.IGP metric
Flags for this route, which was not selected as best for a
particular destination.
Inactive reason
Route being added.Initial
Copyright © 2017, Juniper Networks, Inc.3008
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
