Table 227: Next-hop Types Output Field Values (continued)
DescriptionNext-Hop Type
Resolving next hop.Resolve (rslv)
Regular multicast next hop.Routed multicast (mcrt)
A specific node or set of nodes to which the routing device
forwards packets that match the route prefix.
To qualify as a next-hop type router, the route must meet
the following criteria:
• Must not be a direct or local subnet for the routing
device.
• Must have a next hop that is directly connected to the
routing device.
Router
Routing table next hop.Table
Unicast.Unicast (ucst)
List of unicast next hops. A packet sent to this next hop
goes to any next hop in the list.
Unilist (ulst)
Table 218 on page 3008 describes all possible values for the State output field. A route can
be in more than one state (for example, <Active NoReadvrt Int Ext>).
Table 228: State Output Field Values
DescriptionValue
Route needs accounting.Accounting
Route is active.Active
Path with a lower multiple exit discriminator (MED) is
available.
Always Compare MED
Shorter AS path is available.AS path
Cisco nondeterministic MED is enabled, and a path with a
lower MED is available.
Cisco Non-deterministic MED
selection
Route is a clone.Clone
Length of cluster list sent by the route reflector.Cluster list length
Route has been deleted.Delete
Exterior route.Ex
3123Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
