Juniper ACX2000 Configuration Guide

Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detail(ACX Series routers only) Details of the frame-loss test.Rfc2544
frame-loss test
information :
detailLength of the first burst when test frames are sent, as a measure of number of
seconds at the rate of Kbps.
Initial burst length:
detailMode of the test iteration: Binary or step-down.Test iteration mode
:
detailThe test step percentage for tests. If not specified, the default step-percent is
10 percent. This parameter is ignored for all type of tests other than frame-loss
tests.
Test iteration step
percent
detailThe theoretical limit of the media for the frame size configured for the test. This
value is typically set to the bandwidth of the server being tested.
Theoretical max
bandwidth
detailSize of the test packets in bytes.Test packet size
detailNumber of the test iteration.Iteration
detailPeriod, in seconds, for which the test iteration is run.Duration (sec)
detailThe offered throughput in percentage of the chosen service (such as Layer 3 or
Ethernet pseudowire)
Offered throughput
(percentage)
detailAmount of time that has passed, in seconds, since the start of the test.Elapsed time
detailTheoretical frame rate in packets-per-second.pps
detailNumber of transmitted test packets.Tx Packets
detailNumber of received test packets.Rx Packets
detailNumber of transmitted bytes.Tx Bytes
detailNumber of received bytes.Rx Bytes
detailPercentage of frames that must been forwarded by the router under steady
state (constant) load, but were not forwarded due to lack of resources.
Frame-loss rate %
detailResults of the frame-loss test completed for a certain packet size.Result of the
iteration runs :
detailPercentage of dropped frames for the specified packet sizeFrame-loss rate
(percent) :
detailConsolidated statistics of the frame-loss testRFC2544
Frame-loss test
results summary
Copyright © 2017, Juniper Networks, Inc.3168
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English