Juniper ACX2000

Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detailMode of the test iteration: Binary or step-down.Test iteration mode
:
detailThe test step percentage for tests. If not specified, the default step-percent is
10 percent. This parameter is ignored for all type of tests other than frame-loss
tests.
Test iteration step
percent
detailThe theoretical limit of the media for the frame size configured for the test. This
value is typically set to the bandwidth of the server being tested.
Theoretical max
bandwidth
detailPacket size of the test frames in bytes.Test packet size:
detailNumber of the test iteration.Iteration
detailNumber of packets in the burst.Burst Length
(Packets)
detailAmount of time that has passed, in seconds, since the start of the test.Elapsed time
detailNumber of transmitted test packets.Tx Packets
detailNumber of received test packets.Rx Packets
detailNumber of transmitted bytes.Tx Bytes
detailNumber of received bytes.Rx Bytes
detailResults of the back-to-back frames test completed for a certain packet size.Result of the
iteration runs :
detailNumber of the iteration with the longest burst.Best iteration :
detailTime in seconds of the burst of the iteration with the longest burst.Measured burst
(num sec)
detailNumber of packets during the burst of the iteration with the longest burst.Measured burst
(num pkts)
detail summaryConsolidated statistics of the back-to-back frames test.RFC2544
Back-Back test
results summary:
detail summarySize of the test packets in bytes.Packet Size
detail summaryComputed burst length in terms of number of packets.Measure Burst
length (Packets)
3167Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands