Juniper ACX2000 Configuration Guide

Inet family Configuration:
Egress Interface : ge-0/1/1.0
Source ipv4 address: 192.0.2.1
Destination ipv4 address: 192.0.2.2
Source udp port: 2020
Destination udp port: 3030
Rfc2544 Back-Back test information :
Initial burst length: 20 seconds at 993000 kbps
Test iteration mode : Binary
Test iteration step percent : 50.00 %
Test packet size: 64
Iteration Burst Length Elapsed Tx Rx Tx
Rx
(Packets) time Packets Packets Bytes
Bytes
1 404754 3 404754 404754 27523272
27523272
2 26983680 20 26983680 26983680 1834890240
1834890240
Result of the iteration runs : Back-Back-Frames Test complete for packet size
64
Best iteration : 2
Measured burst (num sec) : 20 sec,
Measured burst (num pkts) : 26983680 packets
Result of the iteration runs : Back-Back-Frames Test complete for packet size
64
Best iteration : 2
Measured burst (num sec) : 20 sec,
Measured burst (num pkts) : 26983680 packets
Test packet size: 1280
Iteration Burst Length Elapsed Tx Rx Tx
Rx
(Packets) time Packets Packets Bytes
Bytes
1 28467 3 28467 28467 36551628
36551628
2 1897920 20 1897920 1897920 2436929280
2436929280
Result of the iteration runs : Back-Back-Frames Test complete for packet size
12
Best iteration : 2
Measured burst (num sec) : 20 sec,
Measured burst (num pkts) : 1897920 packets
RFC2544 Back-Back test results summary:
----------------------------------------
Packet Measure Burst
Size length (Packets)
64 26983680 packets
1280 1897920 packets
show services rpm rfc2544-benchmarking test-id detail (Reflection Test on MX104 Routers)
user@host> show services rpm rfc2544-benchmarking test-id detail 1
3175Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English