Replace number with the following values depending on the LCC configuration:
• 0 through 3, when T640 routers are connected to a TX Matrix router in a routing
matrix.
• 0 through 3, when T1600 routers are connected to a TX Matrix Plus router in a
routing matrix.
• 0 through 7, when T1600 routers are connected to a TX Matrix Plus router with 3D
SIBs in a routing matrix.
• 0, 2, 4, or 6, when T4000 routers are connected to a TX Matrix Plus router with
3D SIBs in a routing matrix.
sfc number—(TX Matrix Plus routers only) (Optional) Display the hostname and version
information about the software running on the TX Matrix Plus router (or switch-fabric
chassis). Replace number with 0.
Additional Information By default, when you issue the show version command on a TX Matrix or TX Matrix Plus
master Routing Engine, the command is broadcast to all the T640 (in a routing matrix
based on a TX Matrix router) or T1600 or T4000 (in a routing matrix based on a TX Matrix
Plus router) master Routing Engines connected to it. Likewise, if you issue the same
command on the TX Matrix or TX Matrix Plus backup Routing Engine, the command is
broadcast to all the T640 (in a routing matrix based on a TX Matrix router) or T1600 or
T4000 (in a routing matrix based on a TX Matrix Plus router) backup Routing Engines
that are connected to it.
Required Privilege
Level
view
List of Sample Output show version (Devices Running Junos OS Release 13.3 and Later) on page 3196
show version on page 3196
show version (TX Matrix Plus Router) on page 3197
show version (TX Matrix Plus Router with 3D SIBs) on page 3199
show version (MX Series Router) on page 3203
show version (QFX3500 Switch) on page 3203
show version (QFabric System) on page 3203
show version component all (QFabric System) on page 3204
show version (ACX5048 Router) on page 3205
show version (ACX5096 Router) on page 3206
3195Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
