clear-counters—(ACX Series routers only) Clear the statistics associated with the
benchmarking test that was run.
routing-instance—(ACX Series routers only) (Optional) Name of the routing instance for
the test.
test-name—(Optional) Name of the benchmarking test that must be started or stopped.
test-id—(Optional) Unique identifier of the test that must be stopped. You can stop a
test based on the test identifier. You can use the test-id option with only the test
services rpm rfc2544-benchmarking stop command.
Additional Information The test session is supported in out-of-service mode for the underlying service. You must
not transmit any traffic to the UNI port, configured as a generator or a reflector, that is
being tested during the duration of the test.
Required Privilege
Level
view
Related
Documentation
Configuring an RFC 2544-Based Benchmarking Test•
• RFC2544-Based Benchmarking Tests Overview
• rfc2544-benchmarking on page 1698
List of Sample Output test services rpm rfc2544-benchmarking test start on page 3212
Output Fields To display the results of the benchmarking test, use the show services rpm
rfc2544-benchmarking test start command.
Sample Output
test services rpm rfc2544-benchmarking test start
user@host> test services rpm rfc2544-benchmarking test test1 start
Test "test1" id 56 started
The response specifies that a test has been started with test id 56. The test ID can be
further used in show commands to view test output.
Copyright © 2017, Juniper Networks, Inc.3212
ACX Series Universal Access Router Configuration Guide
To Previous Page
Loading...
Need help?
General
