Juniper ACX2000 Configuration Guide

show chassis synchronization extensive
user@host> show chassis synchronization extensive
Current clock status : Locked
Clock locked to : Primary
SNMP trap status : Enabled
Configured sources:
Interface : ge-0/0/7
Status : Secondary Index : 136
Clock source state : Clk qualified Priority : Default(8)
Configured QL : SEC ESMC QL : PRC
Clock source type : ifd Clock Event : Clock qualified
Interface State : Up,sec,ESMC Rx(SSM 0x2),ESMC TX(QL SEC/SSM 0xb),
Interface : ge-0/1/1
Status : Primary Index : 138
Clock source state : Clk qualified Priority : Default(8)
Configured QL : PRC ESMC QL : PRC
Clock source type : ifd Clock Event : Clock locked
Interface State : Up,pri,ESMC Rx(SSM 0x2),ESMC TX(QL DNU/SSM 0xf)
show chassis synchronization extensive
user@host> show chassis synchronization extensive
Configured ports:
Name : auxiliary
Rx status : active
Rx message : TL000001433759011353
Current ToD : Mon Jun 8 10:23:31 2015
Last ToD update : Mon Jun 8 10:23:30 2015
GPS receiver status : Lost Sync
UTC Pending : FALSE
UTC Offset : 35
One PPS status : Active
Configured sources:
Interface : gps
Status : Primary Index : 1
Clock source state : Clk failed Priority : Default(6)
Configured QL : PRC ESMC QL : DNU
Clock source type : extern Clock Event : Clock failed
Interface State : Up,pri
show ptp lock-status detail
user@host> show ptp lock-status detail
Lock Status:
Lock State : 1 (FREERUN)
Phase offset : 0.000000000 sec
305Copyright © 2017, Juniper Networks, Inc.
Chapter 9: Configuring Timing and Synchronization

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English