Juniper ACX2000 Configuration Guide

fragment-threshold bytes;
minimum-links number;
mrru bytes;
short-sequence;
family inet {
address address;
}
You can configure the address family as MPLS for the LSQ interfaces in an MLPPP
bundle.
•
PPP control protocol support depends on the processing of the PPP application for
MLPPP bundle interfaces IPv4, Internet Protocol Control Protocol (IPCP), PPP Challenge
Handshake Authentication Protocol (CHAP), and Password Authentication Protocol
(PAP) applications are supported for PPP.
•
Drop timeout configuration is not applicable to ACX routers
•
The member links across MICs cannot be bundled. Only physical interfaces on the
same MIC can be bundled.
•
Fractional T1 and E1 interfaces are not supported. CoS is supported only for full T1 and
E1 interfaces. Selective time slots of T1/E1 cannot be used and full T1/E1 interfaces
must be used.
•
Detailed statistics displayed depend on the parameters supported by the hardware.
The counters that are supported by the hardware are displayed with appropriate values
in the output of the show interfaces lsq-fpc/pic/port detail command. In the following
sample output, the fields that are displayed with a value of 0 denote the fields that
are not supported for computation by ACX routers. In the lsq- interface statistics, non-
fragment statistics of the bundle are not accounted. Non-fragments are typically
treated as single-fragment frames and counted in the fragment statistics.
user@host# show interfaces lsq-1/1/0 detail
Physical interface: lsq-1/1/0, Enabled, Physical link is Up
Interface index: 162, SNMP ifIndex: 550, Generation: 165
Description: LSQ-interface
Link-level type: LinkService, MTU: 1504
Device flags : Present Running
Interface flags: Point-To-Point SNMP-Traps Internal: 0x0
Last flapped : 2015-06-22 19:01:47 PDT (2d 04:56 ago)
Statistics last cleared: 2015-06-23 05:01:49 PDT (1d 18:56 ago)
Traffic statistics:
Input bytes : 108824 208896 bps
Output bytes : 90185 174080 bps
Input packets: 1075 256 pps
Output packets: 1061 256 pps
IPv6 transit statistics:
Input bytes : 0
Output bytes : 0
Input packets: 0
Output packets: 0
Frame exceptions:
Oversized frames 0
Errored input frames 0
Input on disabled link/bundle 0
Output for disabled link/bundle 0
Queuing drops 0
Copyright © 2017, Juniper Networks, Inc.510
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English