user@R1# set auto-targeted-session maximum-sessions 20
8. (Optional) Enable forwarding equivalence class (FEC) deaggregation, which results
in faster global convergence.
[edit protocols ldp]
user@R1# set deaggregate
9. To enable Packet Forwarding Engine local repair, establish a policy that forces the
routing protocol process to install all the next hops for a given route.
This policy ensures that the backup route is installed in the forwarding table used
by the Packet Forwarding Engine to forward traffic to a given destination.
[edit policy-options]
user@R1# set policy-options policy-statement ecmp term 1
user@R1# set then load-balance per-packet
10. Apply the policy to the forwarding table of the local router with the export statement.
[edit routing-options forwarding-table]
user@R1# set export ecmp
Results
From configuration mode, confirm your configuration by entering the show interfaces,
show protocols, show policy-options, and show routing-options commands. If the
output does not display the intended configuration, repeat the instructions in this example
to correct the configuration.
user@R1# show interfaces
ge-1/0/0 {
unit 1 {
description R1->R2;
family inet {
address 1.1.1.1/24;
}
family iso;
family mpls;
}
}
ge-1/5/0 {
unit 12 {
description R1->R6;
family inet {
address 1.1.6.12/24;
}
family iso;
family mpls;
}
}
lo0 {
unit 10 {
Copyright © 2017, Juniper Networks, Inc.574
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
