Juniper ACX2000

Verification
Confirm that the configuration is working properly.
•
Verifying the PCEP Session Status on page 716
•
Verifying the PCE-Controlled LSP Status When LSP Control Is External on page 717
•
Verifying the PCE-Controlled LSP Status When LSP Control Is Local on page 718
Verifying the PCEP Session Status
Purpose Verify the PCEP session status between the PCE and Router PCC when the PCE status
is up.
Action From operational mode, run the show path-computation-client active-pce command.
user@PCC> show path-computation-client active-pce
PCE pce1
General
IP address : 10.209.57.166
Priority : 0
PCE status : PCE_STATE_UP
Session type : PCE_TYPE_STATEFULACTIVE
PCE-mastership : main
Counters
PCReqs Total: 0 last 5min: 0 last hour: 0
PCReps Total: 0 last 5min: 0 last hour: 0
PCRpts Total: 5 last 5min: 5 last hour: 5
PCUpdates Total: 1 last 5min: 1 last hour: 1
Timers
Local Keepalive timer: 30 [s] Dead timer: 120 [s]
Remote Keepalive timer: 30 [s] Dead timer: 120 [s]
Errors
PCErr-recv
PCErr-sent
PCE-PCC-NTFS
PCC-PCE-NTFS
Meaning The output displays information about the current active stateful PCE that Router PCC
is connected to. The PCE status output field indicates the current status of the PCEP
session between the PCE and Router PCC.
For pce1, the status of the PCEP session is PCE_STATE_UP, which indicates that the PCEP
session has been established between the PCEP peers.
Copyright © 2017, Juniper Networks, Inc.716
ACX Series Universal Access Router Configuration Guide