set class-of-service traffic-control-profiles profile-2 atm-service cbr
set class-of-service traffic-control-profiles profile-2 peak-rate 1k
set class-of-service interfaces at-0/0/16 unit 0 output-traffic-control-profile profile-1
set interfaces at-0/0/16 per-unit-scheduler
set class-of-service traceoptions file cos
set class-of-service traceoptions file size 1000000000
set class-of-service traceoptions flag all
Configuring Shaping on an ATM IMA Pseudowire
Step-by-Step
Procedure
The following steps require you to navigate various levels in the configuration hierarchy.
For information about navigating the CLI, see Using the CLI Editor in Configuration Mode
in the CLI User Guide.
To configure shaping on an ATM IMA pseudowire:
1. In configuration mode, go to the [edit class-of-service] hierarchy level:
[edit]
user@host# edit class-of-service
2. Specify the first traffic control profile:
[edit class-of-service]
user@host# edit traffic-control-profiles profile-1
3. Specify the ATM real-time variable bit rate rtvbr service traffic category:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set atm-service rtvbr
4. Define the largest number of cells per second that the shaper processes before it
drops packets:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set peak-rate 5k
5. Define the normal traffic rate averaged over time, from 61 cps through 38,641 cps:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set sustained-rate 3k
6. Define the maximum number of cells that a burst of traffic can contain, from 1
through 4000 cells:
[edit class-of-service traffic-control-profiles profile-1]
user@host# set max-burst-size 400
7. Specify the second traffic control profile:
[edit class-of-service traffic-control-profiles profile-2]
user@host# edit traffic-control-profiles profile-2
Copyright © 2017, Juniper Networks, Inc.904
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
