8. Specify the ATM constant bit rate cbr service traffic category:
[edit class-of-service traffic-control-profiles profile-2]
user@host# set atm-service cbr
9. Define the largest number of cells per second that the shaper processes before it
drops packets:
[edit class-of-service traffic-control-profiles profile-2]
user@host# set peak-rate 1k
10. Define the largest number of cells per second that the shaper processes before it
drops packets:
[edit class-of-service traffic-control-profiles profile-2]
user@host# set peak-rate 1k
11. Apply the first shaping traffic profile to the ATM IMA pseudowire logical interface:
[edit class-of-service]
user@host# edit interfaces at-0/0/16 unit 101 output-traffic-control-profile profile-1
12. Configure the per-unit scheduler:
[edit interfaces at-0/0/16]
user@host# set interfaces at-0/0/16 per-unit-scheduler
Configuring Tracing Operations
Step-by-Step
Procedure
To define tracing operations for the class-of-service (CoS) configuration:
Configure class-of-service (CoS) tracing options:1.
[edit]
user@host# edit class of service traceoptions
2. Create the file to receive the tracing operation output:
[edit class-of-service traceoptions]
user@host# set file cos
3. Define the maximum size of the file:
[edit class-of-service traceoptions]
user@host# set file size 1000000000
4. Specify the tracing operation to perform:
[edit class-of-service traceoptions]
user@host# set flag all
905Copyright © 2017, Juniper Networks, Inc.
Chapter 27: Configuring Class of Service
To Next Page
Loading...
Need help?
General
