Anritsu MS2840A - [:SENSe]:BANDwidth|:BWIDth[:RESolution]:MODE NORMal|CISPr

Chapter 2 SCPI Device Message Details
2-90
[:SENSe]:BANDwidth|:BWIDth[:RESolution]:MODE NORMal|CISPr
Resolution Bandwidth Normal/CISPR
Function
This command switches the Resolution Bandwidth (RBW) mode. When
Couple Time/Freq. Domain is set to Off, each parameter is specified in
accordance with the already-specified frequency axis or time axis
measurement.
Command
[:SENSe]:BANDwidth|:BWIDth[:RESolution]:MODE <mode>
Parameter
<mode>
Resolution Bandwidth (RBW)
NORMal
RBW (in normal cases). This is the Default.
CISPr
CISPR RBW
Details
This function is available when MS2830A-016/116, MS2840A-016/116 is
installed.
Not available when the Measure function is set to On.
Not available when the Gate View function is set to On.
Example of Use
To switch the mode to CISPR RBW.
BAND:MODE CISP
Related command
This command has the same function as the following commands.
[:SENSe]:ACPower:BANDwidth[:RESolution]:MODE
[:SENSe]:CHPower:BANDwidth[:RESolution]:MODE
[:SENSe]:OBWidth:BANDwidth[:RESolution]:MODE
[:SENSe]:BPOWer|:TXPower:BANDwidth[:RESolution]:MODE
:CALCulate:BANDwidth|:BWIDth[:RESolution]:MODE
:CALCulate:ACPower:BANDwidth[:RESolution]:MODE
:CALCulate:CHPower:BANDwidth[:RESolution]:MODE
:CALCulate:OBWidth:BANDwidth[:RESolution]:MODE
:CALCulate:BPOWer|:TXPower:BANDwidth[:RESolution]:MODE