2.14 Spurious Emission Measurement Function
2-719
2
SCPI Device Message Details
[:SENSe]:SPURious[:STATe] ON|OFF|1|0
Measure Spurious Emission
Function
This command executes the Spurious Emission measurement.
Command
[:SENSe]:SPURious[:STATe] <switch>
Parameter
<switch>
Spurious measurement On/Off
ON|1
Spurious measurement is enabled.
OFF|0
Spurious measurement is disabled.
Details
This command is not available in the following cases:
•
When Scale Mode is set to Lin.
•
In Time Domain
If the Spurious Emission measurement is set to On, then the active trace
is set to A.
Example of Use
To set the Spurious measurement to On.
SPUR ON
To Next Page
Loading...
