Anritsu MS2840A - [:SENSe]:SEMask:OFFSet[1]:LIST:FREQuency:STARt <freq_1>[,<freq_2>[,<freq_3>[,<freq_4>[,<freq_5>[,<freq_6>[,<freq_7>[,<freq_8>[,<freq_9>[,<freq_10>[,<freq_11>[,<freq_12>]]]]]]]]]]]

2.13 Spectrum Emission Mask
2-645
2
SCPI Device Message Details
[:SENSe]:SEMask:OFFSet[1]:LIST:FREQuency:STARt
<freq_1>[,<freq_2>[,<freq_3>[,<freq_4>[,<freq_5>[,<freq_6>[,<freq_7>[,<freq
_8>[,<freq_9>[,<freq_10>[,<freq_11>[,<freq_12>]]]]]]]]]]]
Spectrum Emission Mask Offset Start Frequency
Function
This command sets the start frequency of the offset for Spectrum
Emission Mask measurement.
Command
[:SENSe]:SEMask:OFFSet[1]:LIST:FREQuency:STARt <freq_n>
Parameter
<freq_n>
Start frequency of Offset-n
Range 0 to 4999999700 Hz
Resolution 2 Hz
Suffix code HZ,KHZ,KZ,MHZ,MZ,GHZ,GZ
Hz is used when omitted.
Example of Use
To set the start frequency of the offset.
SEM:OFFS:LIST:FREQ:STAR
4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4MHZ,4
MHZ