Anritsu MS2840A - [:SENSe]:AVERage:COUNt <integer>

Chapter 2 SCPI Device Message Details
2-192
[:SENSe]:AVERage:COUNt <integer>
Average Count
Function
This command sets the storage count.
Command
[:SENSe]:AVERage:COUNt <integer>
Parameter
<integer>
Storage count
Range 2 to 9999
Default 10
Details
This command is not available during the Spurious Emission
measurement.
Example of Use
To set the storage count to 110.
AVER:COUN 110
Command
This command has the same function as the following commands.
[:SENSe]:ACPower:AVERage:COUNt
[:SENSe]:CHPower:AVERage:COUNt
[:SENSe]:OBWidth:AVERage:COUNt
[:SENSe]:SEMask:AVERage:COUNt
[:SENSe]:BPOWer|:TXPower:AVERage:COUNt