Anritsu MS2840A - :CALCulate:SPURious[:RANGe][:LIST]:LIMit:ABSolute[:UPPer]:DATA:STOP:AUTO ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0, ON|OFF|1|...

Chapter 2 SCPI Device Message Detail
2-774
:CALCulate:SPURious[:RANGe][:LIST]:LIMit:ABSolute[:UPPer]:DATA:STOP:
AUTO ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,
ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0,ON|OFF|1|0
Spurious Emission Limit Stop Level Auto/Manual
Function
This command sets the absolute level limit of the stop frequency in each
segment for the Spurious Emission measurement to Auto/Manual.
Command
:CALCulate:SPURious[:RANGe][:LIST]:LIMit:ABSolute[:UPPer
]:DATA:STOP:AUTO <switch_n>
Parameter
<switch_n>
Stop frequency of Segment n Auto/Manual
ON|1
Stop frequency is set to Auto.
OFF|0
Stop frequency is set to Manual.
Default On
Details
When set to On, the same as the value set in Limit Start Level is set to
Limit Stop Level.
Example of Use
To set the absolute level limit of the stop frequency in each segment to
Auto/Manual.
CALC:SPUR:LIM:ABS:DATA:STOP:AUTO
ON,ON,ON,ON,OFF,OFF,OFF,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON,ON
,ON,ON