Chapter 2 SCPI Device Message Details
2-130
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:WIDTh:POINt?
Zone Marker Width (by Point) Query
Function
This command queries the zone marker width by the point.
Query
:CALCulate:MARKer[n]:WIDTh:POINt?
Response
<integer>
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted:
M
arker 1
<integer>
Zone marker width
Range 1 to 11, 21, 41, 51, 101, 201, 251, 401, 501, 1001,
2001, 5001, 10001, 30001 (MS269xA Only)
points (number of trace points)
Details
This command is not available during the Spurious Emission
measurement and when Displayed Segment Mode is set to Auto.
Example of Use
To query the zone marker width by the point.
CALC:MARK:WIDT:POIN?
> 501
To Next Page
Loading...
