Anritsu MS2840A - CONF:SPUR; CONTS

Chapter
４
Native Device Message Details
4-72
CONF:SPUR
Spurious Emission Configure
Function
This command sets the Spurious Emission measurement to On.
Command
CONF:SPUR
Details
No measurement is performed.
When Spurious Emission measurement is set to On, the active trace is
set to A.
Example of Use
To set the Spurious Emission measurement to On.
CONF:SPUR
CONTS
Continuous Sweep
Function
This command sets the sweep mode to Continuous and starts continuous
sweep.
Command
CONTS
Example of Use
To start continuous sweep.
CONTS