Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:SET]:RLEVel

Chapter 2 SCPI Device Message Details
2-138
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10[:SET]:RLEVel
Marker to Reference Level
Function
This command sets the marker level to the reference level.
Command
:CALCulate:MARKer[n][:SET]:RLEVel
Parameter
<n>
Marker number
1
Marker 1
2
Marker 2
3
Marker 3
4
Marker 4
5
Marker 5
6
Marker 6
7
Marker 7
8
Marker 8
9
Marker 9
10
Marker 10
When omitted: Marker 1
Details
This command is not available in the following cases:
•
When the marker mode is set to Off.
•
During the Spurious Emission measurement and when Display
Segment Mode is set to Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To set the marker level of the marker 1 to the reference level.
CALC:MARK:RLEV