Anritsu MS2840A - [:SENSe]:BPOWer|:TXPower:BURSt:STOP?; :CALCulate:BPOWer|:TXPower:BURSt:STOP?

Chapter 2 SCPI Device Message Details
2-454
[:SENSe]:BPOWer|:TXPower:BURSt:STOP?
Burst Average Power Stop Time Query
Function
This command queries the stop position (time) for Burst Average Power
measurement.
Query
[:SENSe]:BPOWer|:TXPower:BURSt:STOP?
Response
<time>
Parameter
<time>
Stop position (time)
Range Within the frequency range of trace display
Resolution Formula for calculating the resolution is:
Sweep Time / (Trace Point – 1)
(Minimum value: 1ns)
Suffix code None. Value is returned in S units.
Example of Use
To query the stop position (time) for Burst Average Power measurement.
BPOW:BURS:STOP?
> 0.200000000
Related command
This command has the same function as the following command.
:CALCulate:BPOWer|:TXPower:BURSt:STOP?
:CALCulate:BPOWer|:TXPower:BURSt:STOP?
Burst Average Power Stop Time Query
Function
This command queries the stop position (time) for Burst Average Power
measurement.
Refer to
[:SENSe]:BPOWer|:TXPower:BURSt:STOP?.
Related command
This command has the same function as the following command.
[:SENSe]:BPOWer|:TXPower:BURSt:STOP?