Anritsu MS2840A - [:SENSe]:MIXer:PS[:Center] ON|OFF|1|0

Chapter 2 SCPI Device Message Detail
2-1000
[:SENSe]:MIXer:PS[:Center] ON|OFF|1|0
PS Function
Function
This command enables/disables the PS function, which reverses the
frequency polarity at the center frequency when using High Performance
Waveguide Mixer.
Command
[:SENSe]:MIXer:PS[:Center] <switch>
Parameter
<switch>
PS function
ON|1
Enables PS function.
OFF|0
Disables PS function.
Default Off
Details
This function is available when Option 044/045 is installed for MS2830A.
This function is available when Option 044/046 is installed for MS2840A.
It is only available for High Performance Waveguide Mixer.
This function cannot be set to On when Signal ID is On.
Example of Use
To sweep while reversing the frequency polarity at the center frequency.
MIX:PS ON