Anritsu MS2840A - :CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MINimum

2.5 Signal Search
2-169
2
SCPI Device Message Details
:CALCulate:MARKer[1]|2|3|4|5|6|7|8|9|10:MINimum
Minimum Search
Function
This command moves the marker so that the minimum level point in the
measurement band becomes the center frequency of the zone marker.
Command
:CALCulate:MARKer[n]:MINimum
Parameter
<n>
Marker Number
1
Specifies marker 1
2
Specifies marker 2
3
Specifies marker 3
4
Specifies marker 4
5
Specifies marker 5
6
Specifies marker 6
7
Specifies marker 7
8
Specifies marker 8
9
Specifies marker 9
10
Specifies marker 10
When omitted: Specifies marker 1
Details
This command is not available during Spurious Emission measurement
and when Displayed Segment Mode is Auto.
Not available during Spectrum Emission Mask measurement.
Example of Use
To move the marker 1 to the minimum level point.
CALC:MARK:MIN
Related Command
This command has the same function as the following command.
:CALCulate:ACPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MINimum
:CALCulate:CHPower:MARKer[1]|2|3|4|5|6|7|8|9|10:MINimum
:CALCulate:OBWidth:MARKer[1]|2|3|4|5|6|7|8|9|10:MINimum
:CALCulate:BPOWer|:TXPower:MARKer[1]|2|3|4|5|6|7|8|9|10:
MINimum